You need an account to access this content
Create a free account and get access to all downloads and more!
Marine Control Solution Training
Face-to-face course
Marine Control Solution Training
Location: Vikctor Hasselblads Gata 15, Västra Frölunda421 31, Gothenburg, Sweden
Training fee: 950 EUR per person per day (excluding VAT)
Capacity: 5 participants
Location: Vikctor Hasselblads Gata 15, Västra Frölunda421 31, Gothenburg, Sweden
Training fee: 950 EUR per person per day (excluding VAT)
Capacity: 5 participants
At this basic level training, participants will gain an overview of ComAp Marine solutions, controllers and applications. The course introduces marine-certified architectures, engine control and AC/DC power management systems based on InteliDrive 700 Marine, InteliRPU G2, InteliGen 1000 Marine and InteliMains 1010 Marine controllers. Participants will learn the fundamentals of controller configuration using InteliConfig, including application selection, controller setup, communication basics and commissioning principles. The demonstrated configuration workflow is common across the ComAp controller portfolio.
Practical sessions include controller configuration, engine simulation and an introduction to monitoring and system integration.
After successfully completing this training session, participants will receive ComAp certificates of completion for the course. ComAp certificates are provided at all training locations worldwide, and we ensure that knowledge and expertise remain at the same level.
Agenda
DAY 1
DAY 2
| 09:00 - 12:00 | Marine Portfolio & Applicaions Overview Overview of marine portfolio including marine controllers and accessories. Marine applications overview (EME / PRP / AUX / Generator / Shore …). Marine-certified architecture and non-classified marine solutions. |
| 12:00 - 13:00 | Lunch Break |
| 12:45 - 16:00 | Configuration & Commissioning basics InteliDrive 700 Marine functions, Logical Analog/Binary functions (LAI, LBI), setpoints and protections. Configuration of ECUs and CAN modules including IRPUG2. PLC Editor description. |
DAY 2
| 09:00 - 12:00 | Communication Available communication interfaces and protocols (Modbus RTU/TCP and SNMP), settings, cybersecurity. USB/Ethernet/AirGate/Serial connection. CAN bus and RS485 line connection and troubleshooting. Connection with ECUs, CAN modules and inter-controller communication. Remote communication. Integration of the whole control system. |
| 12:00 - 13:00 | Lunch Break |
| 13:00 - 16:30 16:30 |
Monitoring & InteliScada InteliVision marine displays, InteliSCADA designer and runtime. Marine vessel schema design and controller monitoring. Alarm management and vessel control. Test & Feedback |